Danh mục:
Chia sẻ:

Mô tả

 Annunciator for genset control system
 Fully compatible with new easYgen100/1000 Series

 Freely configurable LEDs
 CAN bus interface
 RS-485 interface
 Power with 12/24Vdc
 Self check features
 Compact design
 USB service port
 Meets the NFPA standards 99 and 110
 CE marked
 UL/cUL listed


 One configurable relay output
 CAN bus serial interface
 RS-485 serial interface
 USB configuration interface
 Up to 16 configurable LED lamps (amber, green, red)
 Up to 2 easYlite-200 can be connected to an easYgen
 RS-485 and CAN bus communication interfaces (both on-board, connects either/or to the easYgen)
 Connection status indicator LED (green)
 1 lamp test button
 1 horn silencing button
 Relay output for operating external alarm horn or to signal connection status
 12/24 Vdc power supply
 Flush mounting to panel front
 Alarm text configuration via ToolKit-SC
 Connects to ToolKit SC via USB service port
 Compact size to fit confined space
 IP65 for outdoor installation


The easYlite-200 is designed to remotely display the status of a Genset control system through a CAN bus or a Modbus RS-485 interface. The easYlite-200 may be used in applications where a remote status indicator is required, which is directly controlled by the generator control unit.

The annunciator provides 16 configurable LEDs. Up to two annunciators can be interfaced with one easYgen. Three colors (Amber, Green and Red) are available for each LED indication. The user may assign either blink or illuminate should an alarm status change.

The monitored status are transmitted from the easYgen to the easYlite-200. The easYlite-200 LEDs change their state if the assigned warning / alarm condition occurs or the status conditions change.

The annunciator is equipped with selfdiagnostic checks and status LED to indicate the connection and LED lamp status to ease the troubleshooting.

The easYlite-200 is equipped with a relay to operate an external alarm horn or to signal connection status.

The unit is configured with a PC via USB interface using ToolKit-SC service tool.